AVS 9000 Bedienungshandbuch PDF herunterladen (Seite 16)

AVS 9000 system ID

There is a system ID at the start of each SMS you receive from the

AVS 9000. This can be changed.

1. Type your PIN code and ID and then the new ID

Example: 000000IDXXXX (where XXXX is the new ID)

2. You will receive a SMS reply confirming the new ID:

Example: XXXX ID CHANGE PASSED (where XXXX is the

new ID)

Tips:

• The ID can be up to 19 digits long

• It can consist of any combination of the numbers 0-9 and

letters A-Z

• The ID is NOT case sensitive (xxxxxx is the same as XXXXXX)

To add a remote

By SMS

1. Make sure the alarm is disarmed and the ignition is off.

2. Type your PIN code and LEARN

Example: 000000LEARN

3. You will receive a SMS reply stating the alarm is ready:

Example: LEARN MODE ACTIVATED SUCCESSFULLY

4. Within 15 secs the siren will begin to chirp and the indicators

flash. As this happens press and hold the bottom button on

the new remote until the chirping and flashing stops.

5. The new remote is now coded in. Test it by arming/disarming

the system with the new remote.

By remote

1. Disarm the alarm.

2. Enter the vehicle and ensure the doors/bonnet/boot are shut.

3. Turn on the ignition.

4. Immediately press and hold the bottom button on the original

remote until the siren starts chirping and the indicators flash

(approximately four seconds) and then release the button.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 30 31

Keine Kommentare

AVS 9000 Bedienungshandbuch Seite 16